This equates to 50 mv per volt or has a 50 1 ratio.
Load cell calibration mv v.
The cell output is rated in millivolts per volt mv v of the difference voltage at full rated mechanical load.
Divide the product from step 2 2 7 volt pounds by sensitivity in millivolts volt times the excitation voltage.
In this example the actual non linearity is about 0 031 using mv v values and 0 032 when using calculated values which is well below the specification.
This load cell sensitivity rating is specified on a load cell data sheet often in the 1 mv v 3 mv v range.
The millivolt output of a non amplified load cell is linearly proportional to the excitation voltage.
Most quality load cells will come with a factory load cell calibration sheet which specifies the actual sensitivity rating for that individual load cell.
Span sensitivity mv v this is the full span output per supply volt characteristic for the load cell wheatstone bridge.
So a 2 96 mv v load cell will provide 29 6 millivolt signal at full load when excited with 10 volts.
Figure 3 above is an example of a morehouse calibration shear web load cell with a non linearity specification of better than 0 05 of full scale.
If the load cell s sensitivity is 3 mv v and the excitation voltage provided by the converter is 10 volts then the divider will be 30 millivolts or 0 03 volts.
This load cell sensitivity value can be used to convert the load cell s output.
The difference voltage proportional to the load then appears on the signal outputs.
